ASME B18.6.3 Slotted Close Tolerance 100 Deg Flat Countersunk Head Machine Screws

ASME B18.6.3 Slotted Close Tolerance 100 Deg Flat Countersunk Head Machine Screws

Dimensions of ASME B18.6.3 Slotted Close Tolerance 100 Deg Flat Countersunk Head Machine Screws

Nominal Size or Basic Screw Diameter Head Diameter, A Head Height, H, Ref Slot Width, J Slot Depth, T Protrusion Above Gaging Diameter, F Gaging Diameter, G
Max Min Max Min Max Min Max Min
4 0.212 0.188 0.049 0.039 0.031 0.024 0.017 0.025 0.019 0.167
6 0.262 0.235 0.060 0.048 0.039 0.030 0.022 0.028 0.021 0.214
8 0.312 0.282 0.072 0.054 0.045 0.036 0.027 0.031 0.023 0.261
10 0.362 0.329 0.083 0.060 0.050 0.042 0.031 0.034 0.026 0.307
1/4 0.477 0.437 0.110 0.075 0.064 0.055 0.042 0.040 0.031 0.415
5/16 0.597 0.550 0.138 0.084 0.072 0.069 0.053 0.047 0.037 0.526
3/8 0.717 0.662 0.165 0.094 0.081 0.083 0.065 0.053 0.042 0.638
7/16 0.837 0.774 0.193 0.094 0.081 0.097 0.076 0.060 0.047 0.750
1/2 0.957 0.887 0.221 0.106 0.091 0.111 0.088 0.066 0.053 0.862
9/16 1.077 1.000 0.249 0.118 0.102 0.125 0.099 0.073 0.058 0.974
5/8 1.197 1.112 0.276 0.133 0.116 0.139 0.111 0.080 0.063 1.086

Note :

  • Where specifying nominal size in decimals, zeros preceding the decimals and in the fourth decimal place shall be omitted.
  • Tabulated values determined from formula for maximum H in Appendix A.
  • No tolerance for gaging diameter is given. If the gaging diameter of the gage used differs from tabulated value, the protrusion will be affected accordingly and the proper protusion values must be recalculated using the formulas.